Engineered herringbone is a type of engineered flooring, which is produced in fixed lengths of 540 / 675 / 810 mm. As the name suggests, it can be installed in herringbone pattern. 

Construction
Consists of two layers- birch plywood base layer (9 mm) and oak top layer (3,2 mm). The top layer is made from a single hardwood lamella.

Sizes
Thickness 12 mm, width 135 mm. Lengths 540 / 675 / 810 mm.

Installation
Can be installed on plywood, OSB, as well as directly on concrete subfloors, including ones with underfloor heating systems. We reccomend to install the flooring by gluing it to the subfloor.

Sanding
Our solid hardwood flooring is carefully sanded at factory, and there is no need for sanding after installation. Each board has tongue and groove across all four edges, as well as v-shaped bevels, allowing them to be connected seamlessly.

Finishing
Finishing can be done both at the factory, as well as after installation. If you prefer to have your flooring pre-finished at the factory, we offer hardwax treatment in various colors. in this case, your flooring is ready to be walked on right after installation.

Grading

The flooring boards are graded in five grades, depending on amount of knots and discoloration. However, there are no loose knots even in the lowest grades; all knots and cracks are filled with putty. The difference between grades is only visual, there are no differences in practical use.